For 20 years I've wanted a plasma cutter, but haven't had an actual valid use before me.
At #HUNV I noticed that the farmhands have !@#-ed up the bucket on the tractor a bit, and I want to repair it by cutting off a 5' long flange, then welding on an equal len of 2" square tube
-
-
4/ Not gonna rush out and get one today, but am going to start thinking about side gigs again. (Also: unclear if current primary gig is going to renew for another 6 months, or wrap up on 31 Dec, so the wise move is no big spending right now.)
Show this threadThanks. Twitter will use this to make your timeline better. UndoUndo
-
-
-
Time to barter...local cutter Co might need some programming aid...the job gets done and you put the cutter in FY20.
-
makes sense...but I like having tools / capabilities I'll save up and get it one of these days.
- Show replies
New conversation -
-
-
This Tweet is unavailable.
-
how deeply have you researched? I'm leaning towards Hobart AirForce. Not the absolute best, but I'm happy w the Hobart MIG I have, and the price is right https://www.amazon.com/Hobart-500566-Airforce-Plasma-Cutter/dp/B0168T1NUC …
- Show replies
-
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.