Success! 3d printed the lost telescope cap cover! With vanity logo too
The tolerance is a little off, so it’s not quite a snug interference fit. Wondering whether to reprint or use this with a bit of tape or something to line it for a snug fit.pic.twitter.com/WE4mbl0zt1
in situations like this i just like to use a little bit of tape, something moderately compliant
-
-
I'm reprinting, just to see if I have enough control over tolerances. Adding 0.5 mm to 2 diameters, and the Cura slice settings say my print res is 0.2188mm (fast). So it'll be interesting... my interference fit range is within tolerance range of print. I can go as fine as 0.0437
-
for Science!
End of conversation
New conversation -
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.
