Moving on to slightly larger prints as I dial this in. ABS fumes are worse than resin; really wish I had PLA right now
pic.twitter.com/HqjcowGdOZ
-
Show this thread
-
This Ender 3 quality is starting to show
pic.twitter.com/kiEPR8HpE51 reply 0 retweets 6 likesShow this thread -
Twitter video quality, not so much
2 replies 1 retweet 5 likesShow this thread -
-
First real FDM print complete
It looks great, even if I’m nowhere near perfect settings. A far cry from resin, maybe, but not bad by any meanspic.twitter.com/KLl9pHFyNo
6 replies 0 retweets 16 likesShow this thread -
Pointed a Raspberry Pi at the Ender 3 so I can keep an eye on it while it prints
pic.twitter.com/2PJaM070hw
6 replies 3 retweets 37 likesShow this thread -
Reading about thermal runaway; how has nobody built a power socket with a built-in smoke detection cutoff switch? That’s gotta be useful in more situations than just 3D printing?
9 replies 1 retweet 20 likesShow this thread -
-
Piece 2 came out great; I’m working my way through a straightforward
@Catalyst1000 set as I dial in my settingspic.twitter.com/JjLYsajrhU
1 reply 0 retweets 13 likesShow this thread -
Loading seems to be taking a while.
Twitter may be over capacity or experiencing a momentary hiccup. Try again or visit Twitter Status for more information.