gec

@3Dgec

learning, hacking, reprap and medicine

Vrijeme pridruživanja: rujan 2016.

Tweetovi

Blokirali ste korisnika/cu @3Dgec

Jeste li sigurni da želite vidjeti te tweetove? Time nećete deblokirati korisnika/cu @3Dgec

  1. 30. sij

    I was tired of pens drying out when plotting so I tried acrylic paint with a quite broad brush (printing a perlin spiral from ). There's still a lot to learn but I like the handmade appearance. Will add some more layers next time..

    Poništi
  2. 22. sij

    Was at the Vera Molnar exhibition at MuDA in Zürich () - very fascinating and inspirational! It's until Feb. 9th. Started drawing right afterwards: a spiral mod. Can't wait to start plotting.

    Poništi
  3. 12. lis 2019.

    I'd like to see no. 2 plotted but those are all great.

    Poništi
  4. 1. sij 2019.

    Short summary of at : Great feedback from the community, lot's of people interested. Easy setup but manual calibration too demanding, at least for a congress (need those encoders which didn't arrive in time).Timing belts work great. Thanks for support

    Poništi
  5. 28. pro 2018.

    Spotting a behind a unicorn

    Poništi
  6. 28. pro 2018.
    Poništi
  7. 27. pro 2018.

    Assembling my on with help from chris. Looking forward to print.

    Poništi
  8. proslijedio/la je Tweet
    17. pro 2018.

    This is the John Oliver footage they didn't air in the UK for reasons so stupid I'm going to have to just let him explain in the tweet below.

    Prikaži ovu nit
    Poništi
  9. 28. stu 2018.

    Awareness of the problems with anonymization interestingly raised by Prof. Christian Lovis , one of the speaker at symposium

    Poništi
  10. 28. stu 2018.

    Building a Tripod for the while some of my ordered parts hang around customs at the airport for over a month now.

    Poništi
  11. proslijedio/la je Tweet

    „Eigentlich will ich nur Mensch sein“‘ sagte einmal der syrische Demokratie-Aktivist Raed Fares, der jetzt von Unbekannten in der Provinz Idlib niedergeschossen wurde. Hier in Erinnerung an ihn, ein älterer Bericht.

    Poništi
  12. 17. stu 2018.

    HP3 with timing belts and moving again (after some burned parts..) with most recent FM from . Still more dry testing needed. Hope to finish for ..

    Poništi
  13. 23. lis 2018.

    Used the hp4 belt drive from to upgrade my hp3 with mechaduino since I'm lacking . ABC in the corners is already working (I2C throug CAT6 cables). control still needs some adjustments but I'm really happy so far. Thanks to Tobben!

    Poništi

Čini se da učitavanje traje već neko vrijeme.

Twitter je možda preopterećen ili ima kratkotrajnih poteškoća u radu. Pokušajte ponovno ili potražite dodatne informacije u odjeljku Status Twittera.

    Možda bi vam se svidjelo i ovo:

    ·